atkinsons
01-20-2008, 06:53 PM
Hello all,
Has anyone figured out how to adjust the simulators settings to allow the simulator to read a transvenous pacer? I stripped the wire set of a transvenous pacer and direct connected them to the pacer disk. The problem...is that the simulator will only read 40ma and above. A tranvenous pacer starts at o and goes up to 20ma. Any help is appreciated.
Has anyone figured out how to adjust the simulators settings to allow the simulator to read a transvenous pacer? I stripped the wire set of a transvenous pacer and direct connected them to the pacer disk. The problem...is that the simulator will only read 40ma and above. A tranvenous pacer starts at o and goes up to 20ma. Any help is appreciated.